KPM300 driver package for Custom Engineering Spa 
Windows Nt (only serial interface)
Windows 2000 (both USB and serial interface).
Windows XP (both USB and serial interface).

Installation procedure:
a) Serial interface
For a serial interface printer (Win Nt W2k and XP) you must execute the standard
printer installation procedure.
The needed file are stored into: "..\XXX rel 3.XXX" directory.
b) USB interface
For an USB interface you must plug the printer into USB port. The printer will be
recognized, and the setup installation Printer Wizard start. To complete the
installation procedure follow the Printer Wizard steps.

The needed file are stored into: "..\XXX rel 3.XXX" directory.

This driver supports some kind of printer:
"Custom KPM300 80mm (200dpi)" and "Custom KPM300 82.5mm (200dpi)"

The "Custom KPM300 80mm (200dpi)" prints on a paper width size of 80mm but the printable
region width is 76mm.

The "Custom KPM300 82.5mm (200dpi)" prints on a paper width size of 82.5mm but the printable
region width is 80mm.

Every printer supports some page format:

Custom KPM300 80mm (200dpi)

"KPM300 Roll 80mm"
"KPM300 Roll Short 80mm"
"KPM300 80x80mm"
"KPM300 80x120mm"
"KPM300 80x160mm"
"KPM300 80x200mm"
"KPM300 80x240mm"
"KPM300 80x280mm"
"KPM300 80x400mm"

Custom KPM300 82.5mm (200dpi)

"KPM300 Roll 82.5mm"
"KPM300 Roll Short 82.5mm"
"KPM300 82.5x82.5mm"
"KPM300 82.5x125mm"
"KPM300 82.5x165mm"
"KPM300 82.5x205mm"
"KPM300 82.5x245mm"
"KPM300 82.5x285mm"
"KPM300 82.5x405mm"

If the system driver properties section show these format page and other not here
specified, you must select only the above mentioned pages format.